Effect of Abrasive Machining on the Electrical Properties Cu86Mn12Ni2 Alloy Shunts

Misti, Nabilah, Birkett, Martin, Penlington, Roger and Bell, David (2017) Effect of Abrasive Machining on the Electrical Properties Cu86Mn12Ni2 Alloy Shunts. Materials, 10 (8). p. 876. ISSN 1996-1944

[img]
Preview
Text (Article)
materials-10-00876-final published paper.pdf - Published Version
Available under License Creative Commons Attribution 4.0.

Download (3MB) | Preview
Official URL: http://www.mdpi.com/1996-1944/10/8/876

Abstract

This paper studies the effect of abrasive trimming on the electrical properties of Cu86Mn12Ni2 Manganin alloy shunt resistors. A precision abrasive trimming system for fine tuning the resistance tolerance of high current Manganin shunt resistors is proposed. The system is shown to be capable of reducing the resistance tolerance of 100 μΩ shunts from their standard value of ±5% to <±1% by removing controlled amounts of Manganin material using a square cut trim geometry. The temperature coefficient of resistance (TCR), high current, and high temperature performance of the trimmed shunts was compared to that of untrimmed parts to determine if trimming had any detrimental effect on these key electrical performance parameters of the device. It was shown that the TCR value was reduced following trimming with typical results of +106 ppm/°C and +93 ppm/°C for untrimmed and trimmed parts respectively. When subjected to a high current of 200 A the trimmed parts showed a slight increase in temperature rise to 203 °C, as compared to 194 °C for the untrimmed parts, but both had significant temporary increases in resistance of up to 1.3 μΩ. The results for resistance change following high temperature storage at 200 °C for 168 h were also significant for both untrimmed and trimmed parts with shifts of 1.85% and 2.29% respectively and these results were related to surface oxidation of the Manganin alloy which was accelerated for the freshly exposed surfaces of the trimmed part.

Item Type: Article
Uncontrolled Keywords: abrasive machining, Manganin alloy, shunt resistor
Subjects: H300 Mechanical Engineering
Department: Faculties > Engineering and Environment > Mechanical and Construction Engineering
Depositing User: Martin Birkett
Date Deposited: 31 Jul 2017 10:41
Last Modified: 31 Jul 2017 10:41
URI: http://nrl.northumbria.ac.uk/id/eprint/31429

Actions (login required)

View Item View Item

Downloads

Downloads per month over past year

View more statistics


Policies: NRL Policies | NRL University Deposit Policy | NRL Deposit Licence