Power generation from waste heat in a food processing application

Aneke, Mathew, Agnew, Brian, Underwood, Chris, Wu, Hongwei and Masheiti, Salah (2012) Power generation from waste heat in a food processing application. Applied Thermal Engineering, 36. pp. 171-180. ISSN 1359-4311

Full text not available from this repository. (Request a copy)
Official URL: http://dx.doi.org/10.1016/j.applthermaleng.2011.12...

Abstract

In this paper, the potential of recovering waste heat from the fryer section and exhaust stream sent to the stack of a typical potato crisps or chips manufacturing plant and using the heat to drive an Organic Rankine Cycle (ORC) system for power generation has been presented. Five different ORC system Options (A, B, C, D and E) were considered. The first two options (A and B) make use of the waste heat from the foul gas and exhaust to stack respectively for power generation using a single ORC system each while the third option (option C) makes use of a novel dual heat source single ORC system where the low temperature waste heat from the foul gas is used to provide preheating and the high temperature waste from the exhaust to the stack used to provide the evaporation. Option D also shows a dual heat source ORC system where the high temperature waste heat to the exhaust stack is used to provide the preheating while the lower temperature foul gas is used for the evaporation (reverse of option C in terms of waste heat usage) while option E makes use of a reheat cycle where the waste heat from the foul gas is used to provide the reheating of the working fluid exiting the turbine. In terms of waste heat usage, the combination of options A and B can be compared with options C, D and E.
The simulation result shows that in terms of net power generation, cooling water requirement, and working fluid (R245fa) requirement, the combination of Options A and B gives the best power generation result and this is similar as the result produced by Option C. Following option C is option E which gave a better result than option D. The entropy generation analysis showed that the entropy generation is inversely proportional to the power output.

It was also observed that the net power generation for the ORC configuration adopted in this paper (option C) meets the average daily power requirement of the crisps manufacturing process as well as 98.58% of the daily peak power requirement.

Item Type: Article
Uncontrolled Keywords: Crisps, chips, waste heat, power generation, dual heat source, ORC
Subjects: H300 Mechanical Engineering
Department: Faculties > Engineering and Environment > Architecture and Built Environment
Depositing User: Chris Underwood
Date Deposited: 15 Mar 2012 12:39
Last Modified: 20 Nov 2015 14:55
URI: http://nrl.northumbria.ac.uk/id/eprint/5777

Actions (login required)

View Item View Item

Downloads

Downloads per month over past year

View more statistics


Policies: NRL Policies | NRL University Deposit Policy | NRL Deposit Licence